This can be done by loosing up the upper and To achieve this you must first remove the steering knuckle from the vehicle. The front wheel hub on the Chevy Trax gets pressed into the steering knuckle and will need to be pressed out in order to beĬhanged. The torque specs for the inner tie rod are 65 ft-lbs.Ĭhevy Trax Outer Tie Rod Torque Spec : 22 ft-lbs + 130°Ĭhevy Trax Inner Tie Rod Torque Spec : 65 ft-lbs Installing the inner tie rod as well you will need a special tool to loosen and tighten Be sure to tightenīack up the nut on the middle of the tie rod to ensure it does not move your alignment. Once you get the nut back in place you can torque it to 22 ft-lbs plus an additional 130 degree turn. Once the outer tie rod is off you can now screw on the new part and reinstall it the same way it had been This helps to avoidĪlignment costs and hassles, although you may still want to get your vehicle realigned. It takes to come off so that I can then use the same number when installing the new part. To hold the inner tie rod and spin off the outer tie rod. If you want to replace just the outer portion of the tie rod you can use a wrench Once removed you can now tap out the tie rod from the spindle and You may also use a wire brush to clean off the threads prior to removal and or use penatrating oil toĪid in the removal. I suggest using a pair of vice grips to hold the portion of the bolt to prevent it from The inner part of the tie rod uses an nut that will need to be removed, this nut may spin depending on how Once the tire is off you can now access the old tie rod and remove it for replacement. Once the vehicle is in the air you can remove the corresponding tire for the side that you want to change the This can beĭone by raising the vehicle up by either the use of a floor jack or a vehicle hoist. To install a new tie rod on a Chevy Trax you must first remove the old one from the vehicle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |